Laser Beauty Machine Supplier - Beauty Equipment ManufactureThe basic process of OPT hair removal in beauty salons-Beijing Zhenhuimei Beauty Equipment Co., Ltd.
First, the communication before the operation, the main communication is what kind of feeling will be felt during the hair removal process, what will be the performance after the hair removal process, and the customer's feelings during the hair removal process should be expressed in time, such as no feeling, such as tingling sensation!
Second, take pictures, and take pictures of the parts to be operated for file.
Third, prepare the skin, that is, shave off the hair. If it is the face or very fine velvet, you don’t need to scrape it, you can consider hanging it dry, (I will talk about this later)
Fourth, apply the gel: the gel should not be too thick. Now it is fast sliding hair removal. A thin layer of gel is enough. The main purpose is to improve the lubrication and facilitate the sliding operation. During the sliding process, the gel may be caught by the handle Push it aside, it will also dry out, at this time you can reapply the gel evenly to keep it lubricated and comfortable throughout the operation.
Fifth, wear goggles and protect the eyes of customers.
Sixth, if it is OPT, select the 640 filter to turn on and adjust the parameters, test the spot, and determine the parameters. The parameters should be increased slowly from low to high, and the final parameters should be based on the customer's feelings as the reference standard, and the standard should be hot or slightly hot.
Seventh, the formal operation, the handle is close to the skin, slide at a constant speed, control the sliding speed according to the frequency used, not too fast, not too slow, too slow will increase the pain, or even burn the skin, too fast to reach the temperature to make Effect. In general, it is to find the feeling that can spread the light evenly on the skin! Generally, it is enough to slide 6-8 times, depending on the skin condition of the customer. The clinical end point is redness of the skin, and it is enough to feel a lot of heat under the skin when pressed.
Eighth, postoperative care. Cool the skin, cool down the skin, and avoid some inconvenience to customers caused by excessive heat under the skin. The specific method is, do not remove the gel immediately, you can add some cool gel on it, apply it for fifteen to twenty minutes, remove it, and then clean it. Five minutes after cleaning, it is fine if the customer has no uncomfortable reaction. At this point, one hair removal is complete. When the customer cools down the skin, you can tell the customer the precautions. Customer notice: tell the customer not to take a hot bath or sauna for 24 hours. If you want to wash, you can only take a shower with warm and cold water at about 30 degrees. In five to seven days, some small hair stubbles will emerge, which are left under the skin and grow out of inertia. You can use small tweezers to pull them out. Some of them can be pulled out directly without feeling, about one-third to four One-third of the hair can be pulled out. If all the stubble is painful when pulled out, it means that the hair removal is invalid. This is also the judgment of the hair removal.No effective most accurate way! If there is invalid hair removal, you need to find out the reason. If all the procedures are fine, you can increase the energy and the number of sliding times for the next hair removal.
.jpg)
